大鼠牙齿空间移动评估及牙槽骨微观结构变化追踪研究
DOI:
作者:
作者单位:

1.南京医科大学附属口腔医院正畸科;2.南京林业大学机械电子工程学院;3.口腔疾病研究与防治国家级重点实验室培育建设点

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金(82371000,82071143,82101079);国家重点研发计划(2022YFC2402103, 2023YFC2413605);江苏省重点研发计划(BE2022795);江苏省科学技术厅社会发展面上项目(BE2023836)


Evaluation of tooth spatial movement and tracking of microstructural changes in the alveolar bone in rats
Author:
Affiliation:

Department of Orthodontics,The Affiliated Stomatological Hospital of Nanjing Medical University

Fund Project:

the National Natural Science Foundation of China (82371000, 82071143, 82101079); the National Key Research and Development Program of China (2022YFC2402103, 2023YFC2413605); the Key Research and Development Program of Jiangsu Province (BE2022795, BE2023836)

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    目的:Micro-CT活体扫描观测并量化正畸力下大鼠的牙齿移动和张力区及压力区骨小梁微观结构的连续变化情况。方法:对5只雄性8周龄SD大鼠的左侧上颌第一磨牙施加50 g矫治力,使用Micro-CT在加力前及加力后的不同时间点对大鼠进行活体扫描,在统一空间坐标系下计算大鼠正畸牙齿移动距离,并测量统计移动牙张力区及压力区的骨小梁微观形态和力学特性相关参数,分析其动态变化特征。结果:大鼠磨牙在0-3 d有明显位移,3-14 d移动速率下降,21-28 d速率增加(P<0.001);张力区及压力区多项骨小梁参数分别以7d、14 d为转折点,骨体积分数(bone volume fraction,BV/TV)和骨小梁厚度(trabecular thickness,Tb. Th)先下降后升高,孔隙总体积[total volume of pore space,Po. V(tot)]、结构模型指数(structure model index,SMI)、骨小梁间隙(trabecular separation,Tb. Sp)和分形维数(fractal dimension,FD)反之,牙移动前期张力区增量斜率较压力区更大,牙移动后期BV/TV、Po. V(tot)、SMI和Tb. Sp数值在张力区及压力区有显著差异(P<0.05)。结论:大鼠正畸牙移动具有三阶段性;张力区及压力区骨小梁微观结构改建存在差异,骨量及骨质量均先降低后升高,并分别在7 d和14 d前后达到最低点;张力区的骨吸收活跃期较早,张力区牙槽骨骨形成滞后于压力区骨吸收。

    Abstract:

    Objective: This study aimed to observe and quantify the continuous changes in dental movement and trabecular microstructure in tension and pressure zones of rats under orthodontic force using in vivo Micro-CT scanning. Methods: A 50g orthodontic force was applied to the left maxillary first molar of five male 8-week-old SD rats. The rats were scanned in vivo at different time points using Micro-CT. The distance of orthodontic tooth movement was calculated in a unified spatial coordinate system. Additionally, trabecular micro-morphological and mechanical property-related parameters in the tension and pressure zones of the moved teeth were measured and statistically analyzed. Results: There was significant displacement of the rat molars within the first 0-3 days, with a decrease in movement rate between 3-14 days, followed by an increase in rate from 21-28 days (P<0.001). Multiple trabecular parameters in both tension and pressure zones showed turning points at 7 days and 14 days, respectively. Specifically, bone volume fraction (BV/TV) and trabecular thickness (Tb. Th) first decreased and then increased, while total porosity volume [Po. V(tot)], structure model index (SMI), trabecular separation (Tb. Sp), and fractal dimension (FD) exhibited the opposite trend. During the early stage of tooth movement, the slope of increase in trabecular parameters was greater in the tension zone compared to the pressure zone. In the later stage of tooth movement, there were significant differences in the values of BV/TV, Po. V(tot), SMI, and Tb. Sp between the tension and pressure zones (P<0.05). Conclusion: Orthodontic tooth movement in rats occurs in three stages. There are differences in trabecular microstructure remodeling between tension and pressure zones, with bone mass and bone quality both decreasing first and then increasing, reaching their lowest points around 7 days and 14 days, respectively. The active phase of bone resorption in the tension zone occurs earlier, and bone formation in the alveolar bone of the tension zone lags behind bone resorption in the pressure zone.

    参考文献
    相似文献
    引证文献
引用本文
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2024-11-18
  • 最后修改日期:2025-01-06
  • 录用日期:2025-03-07
  • 在线发布日期:
  • 出版日期:
关闭